Let AJ Adhesives Compare Your Adhesive TDS Sheets

AJ Adhesives | Week #33

Let AJ Adhesives Compare Your Adhesive TDS Sheets

August 19, 2026

Adhesive problems rarely start with the adhesive itself. They start with a spec that no longer fits. Maybe your line speed changed. Maybe a substrate did. Maybe the formulation was updated, and nobody flagged it. Whatever the cause, the fix starts with an adhesive spec comparison, and reading one data sheet on your own only gets you so far. This is where an AJ Adhesives rep steps in. We compare adhesive TDS sheets to your actual production conditions, run a trial on your equipment, and, in some cases, can develop a custom adhesive formulation when an off-the-shelf option won’t cut it.

Why a TDS Alone Doesn’t Solve Your Problem

A technical data sheet shows what a product does under lab conditions. It does not show how that product performs on your specific line. It doesn’t account for your substrates. It doesn’t account for your line speed either. That gap is exactly where problems show up.

For example, a viscosity number can look fine on paper. It can still run wrong once it hits your equipment. Reading the numbers is only step one of the evaluation process.

These gaps show up in a few common situations.

A supplier updates a formulation without much notice.
A new SKU calls for a different substrate.
Or a line runs faster than it did when the original adhesive was specified.

Each one is worth a fresh look at the spec, not just a guess based on what worked last time.

How AJ Adhesives Reps Compare Adhesive TDS Sheets for You

When you’re facing a performance issue, a formulation update, or a new application, our reps don’t just hand you a data sheet and wish you luck. We compare adhesive TDS sheets against your current setup, evaluating each element, including:

Viscosity, and the test temperature it was measured at
Open time and set speed, matched against your actual line speed
Application temperature range for your equipment
Softening point or solids content, depending on adhesive type
Bond strength or peel adhesion, and the test standard behind it
Compliance details relevant to your application, like FDA status

We flag mismatched specs. We flag missing details too. And we catch specs that look close enough on paper, but won’t behave the same way in your plant.

Matching Test Conditions Before You Compare Adhesive TDS Sheets

Numbers only mean something when the test behind them matches. A peel value tested at 90 degrees isn’t the same as one tested at 180 degrees. Even if both sheets call it “peel strength.”

Our reps catch that kind of mismatch early. That way, it never becomes a bad decision on your part.

Confirming Fit With a Real Line Trial

A spec comparison narrows things down. But paper only goes so far. Real performance depends on your substrates, your speed, and your plant environment.

That’s why AJ Adhesives can run an on-line trial before you commit to any change. We help test the adhesive on your actual equipment, under your actual conditions. That way, the decision rests on real results, not just a data sheet.

When Standard Options Fall Short, We Build a Custom Adhesive Formulation

Sometimes the comparison shows that no off-the-shelf adhesive quite fits your application. That’s when our team can build something tailored to your substrate, your speed, and your performance goals.

You don’t have to choose between “close enough” and figuring it out alone. AJ Adhesives handles that work with you, start to finish.